Artificial Grass Seams and Edging in Riyadh — Making Joins Disappear and Edges Stay Put

Before cutting anything we sketch a roll layout: where the first roll starts, which way the pile leans and where the seams will fall. We aim for as few seams as possible, away from main walking paths and play zones, with the pile leaning toward the most visible side of the garden.

Pile direction first

Artificial grass reflects light differently depending on how the fibres lean. All rolls are laid in the same direction, and a roll that arrives reversed is turned before cutting. This single step prevents many of the visible seams that garden owners complain about.

Trimming and bringing the rolls together

We trim the fibre-free selvedge from both roll edges so the first stitch row stays intact, then bring the rolls together until the fibres touch without overlapping or leaving a gap. If a visible gap remains after cutting we redo the cut rather than let adhesive cover it.

Tape and adhesive

Seaming tape goes under both edges, then an adhesive suited to the backing is spread and the rolls are pressed down in sequence, taking care that no fibres are trapped in the glue. In Riyadh we watch the temperature because it changes setting time, and we work in short sections so the adhesive does not skin over before pressing.

We follow the adhesive manufacturer’s waiting and loading times and do not quote fixed times here, because they differ between products.

Fixing edges and borders

Along walls and fences the grass is fixed with suitable nails or pins at planned spacing, with the heads hidden among the fibres. In open gardens we use a solid border of concrete, timber or plastic edging that stops creep and keeps the shape along paths and planters.

For roofs and balconies see also rooftop artificial grass and balconies for what is specific to those places.

Curves and corners

Gardens with curved paths and round planters need more careful cutting, so we first cut a rough template and trim the final edge after the grass is laid, so that it follows the solid border exactly. In inside and outside corners we avoid pulling the grass tight, which can make it lift later.

Around trees and posts we cut circular openings and fix the edges so bare backing never shows.

After the join: brushing and finishing

Once the seam has set we brush the fibres up to blend the join, remove fibres stuck in adhesive and check the edges again. Where the lawn will be topped with sand or infill, it is added only after every seam is confirmed secure.

Checking after handover

We suggest checking seams and edges after the first weeks of use and after the first long hot spell, because heat and traffic reveal any weakness. If you see a seam opening or an edge lifting, send us a photo on WhatsApp so we can advise before it spreads.

Regular care such as brushing and removing leaves keeps the surface looking good; we collected it in artificial grass maintenance.