Split the area into simple shapes
An L-shaped garden or one with corners is divided into rectangles and triangles. Work out each area and add them.
You cannot get an accurate artificial grass quote without a clear area. This page helps you work out the area from length and width and add a waste allowance, then explains why the amount you order may differ from the ground area, and how roll width, seams, edges and the base affect quantity. The figure you get here is for planning, and we confirm it at the inspection before work begins.


Enter the length and width of the space in metres and choose a waste allowance, and you will see the area and the suggested order quantity (length × width, then waste added). For gardens with several sections, calculate each section and add the results.
Gardens and roofs vary in shape, so measuring needs particular care. Learn the basics in the flooring measurement guide, then apply these rules to your space.
An L-shaped garden or one with corners is divided into rectangles and triangles. Work out each area and add them.
Walls and fences may not be parallel. Take the larger figure so the quantity does not fall short.
Round or curved shapes need more careful working, and they usually raise waste because more cutting is needed.
Areas that will not be covered are not counted, but leaving gaps around trees and seating increases cutting. We discuss this at the inspection.
Narrow paths and strips around a pool or seating need grass too, so measure them separately.
Photos with a rough sketch let us review the measurements with you at the inspection.
Artificial grass comes in rolls of fixed width, so it is not cut by the square metre like fabric. The quantity you must order may therefore exceed the ground area even without great waste, because the fixed width does not always match the width of your garden.
Always ask what roll width is available for the product you want. If your garden is wider than the roll you will join two rolls with a seam, and if it is narrower you may trim off the excess. This is what makes the order exceed the net area.
Pile direction should be consistent between pieces so no colour difference shows. This affects how the grass is cut and the waste. See seams, joins and edging for details.
Cutting around curved shapes leaves unused offcuts, so waste rises in gardens with curved paths or flower beds. For layout ideas see garden design ideas.
Preparing the ground and drainage does not add to the grass quantity but affects cost and time, as explained in base and drainage for artificial grass.
Estimate area, quantity and material cost from the per-metre price in your quote.
How roll width affects waste, seams and pile direction.
Send us the result with photos of the space and we will review it with you at an inspection in Riyadh before the final quantity is agreed.
| Case | Measurements | Area | Suggested quantity |
|---|---|---|---|
| Rectangular garden | 10 m × 6 m | 60 m² | 66 m² with 10% added |
| Villa roof | 8 m × 5 m | 40 m² | 44 m² with 10% added |
| Small balcony | 4 m × 2.5 m | 10 m² | 10.5 m² with 5% added |
| Garden with curved edges | 12 m × 7 m | 84 m² | 96.6 m² with 15% added |
Record length and width at the widest point, including side strips.
Multiply length by width and split irregular shapes.
Choose the allowance for the shape and curves, then add up.
The actual quantity may change with roll width and seams.
We review them with you at the inspection and correct any figure before ordering.
Even with the right quantity, fitting can go wrong if edges and seams are neglected. Edges are fixed so they do not lift or cause trips, and seams are hidden so no visible line shows between rolls.
So alongside the area we work out the total length of edges to fix and the expected number of seams, and show you the working method at the inspection. Read more in artificial grass installation in Riyadh.

Guessing by eye causes large errors. Use a tape measure and write the figures down.
The real quantity is tied to the fixed roll width, not only square metres.
A shortfall at the end of fitting may mean a new batch with a colour difference.
The right quantity does not make up for an uneven base or no drainage.
Multiply length by width in metres for square metres, split irregular areas into simple shapes, add them up and include a waste allowance.
It ranges from a small allowance for simple rectangles to a higher one for curved edges and trees. It is a planning rule confirmed at the inspection.
Because grass comes in rolls of fixed width, and cutting, seams and pile direction can require more material.
No. It gives area and suggested quantity only. Price depends on pile height, density and base; see artificial grass prices.
Do not count them as grass, but cutting around them raises waste, which we discuss at the inspection.
Usually yes, since a level base and good drainage are the foundation of a successful fit.
It depends on use, and the explanation is in the pile height guide.
Yes in the same way, and we take weight and drainage into account at the inspection.
It depends on the area and the base, and we do not quote a figure before the inspection.
Use the WhatsApp button under the calculator or contact us and send the measurements with photos of the space.
Send the area you calculated and we will review it with you before the quote is settled.
A comparison to help you decide.
Density and yarn explained.
Quick steps to ask for an offer.
A putting or mini golf corner for a garden or roof: base, drainage and edges.
Wholesale artificial grass in Riyadh for contractors, landscapers and projects: choose type and pile height, calculate quantities and coordinate…
A flooring bill of quantities (BOQ) for projects in Riyadh: room areas, waste, skirting and underlay, and what to put in a tender. Ask us to…